155 $
Description
| Brand: | Mitsubishi Rayon | Model: | Mint Diamana Blueboard 63 x5ct ladies/ 45.5" long |
NOTE: THIS LISTING IS FOR THIS SHAFT AN ALMOST MINT MITSUBISHI DIAMANA BLUEBOARD 63 X 5ct LADIES FLEX SHAFT, WITH ALL THE SINGLE COG CALLAWAY SLEEVES INSTALLED, SUCH AS THE RAZR, RAZR FIT, RAZR FIT EXTREME, OPTIFIT, X-HOT, X-HOT PRO or an I-MIX SLEEVE INSTALLED ON THE SHAFT FOR $155.00 W/FREE SHIPPING & WILL COME WITH A GRIP OF THE BUYERS CHOICE, FROM MY SELECTION, ALSO I NEED TO KNOW THE LENGTH THAT THE BUYER WANTS THE SHAFT TO BE, MEASURE FROM THE END OF THE SLEEVE TO THE END OF THE BUTT WITH THE SHAFT REMOVED FROM YOUR HEAD.
NOTE: I ALSO HAVE IN STOCK THE TOUR DUAL COG SLEEVE THAT REPLACES THIS SINGLE COG SLEEVE AND HAS TWICE THE SETTINGS AS THE SINGLE COG SLEEVE FOR $10.00 EXTRA, LET ME KNOW AT CHECKOUT.
UP FOR SALE ON BUY-IT-NOW IS A MINT 45.50 inches long Mitsubishi Rayon Diamana Blueboard 63 Gram X 5ct Ladies shaft for 155.00 with FREE SHIPPING with the I-Mix or either Single Cog Callaway sleeve listed above, installed and ready to go to fit right into your driver head or I will install the shaft with any of the other sleeves listed below, if needed instead, it is in almost mint condition and is 45.50 inches long and will play 46.5-47 inches long in most drivers or I can trim it to the length that you specify or I can extend it to whatever length the buyer wants, even out to 46 inches which would make it play 48 inches long in most drivers, at the longer 48 inch length it will increase your swing speed 6-10 mph and give you between 20-30 yards more distance. The shaft will come with whichever sleeve you the buyer will need for your application from the last two pictures above or I can install into any of the epoxied heads also. This shaft is a nice looking mid/ high kick shaft, with a mid tip section to give you a low to mid ball flight, depending on your loft, swing speed, launch angle & swing type it sells for 300.00 new and is very rare and hard to come by. They have a low enough torque that they won't open up & cause a bad fade or slice. The shaft will come ready to install into your specific driver with a new grip from my stock selection and with the shaft sleeve of your choice such as any of the Taylormade sleeves,R-15, M-1, R-1, SLDR, Jetspeed, R-11, R-9, RBZ, or RBZ Stage 2 or an aftermarket Titleist sleeve for a Titleist 910/913/915 D-2 or D-3 driver or either of the fairway wd. sleeves or the Callaway I-mix or a single cog RAZR, Razr Fit, Rarz Fit Extreme, Optifit, X Hot or X Hot Pro sleeve or all the older Cobra sleeves, such as the S-2,S-3, ZL, ZL Encore, L5V or an AMP sleeve or the Cleveland Classic XL or Custom 588 or either Adams sleeve, the XTD or the Fast 12 LS/Speedline sleeve for $155.00 for either of the Dual Cog Sleeves such as the Optifit/ Razr/ X - Hot Tour sleeve or for the Big Bertha/B.B. Alpha/Optiforce/X-2-Hot, Big Bertha V-Series or the XR, Alpha 815,816/Double Diamond 815 sleeve for all the Callaway heads for the Buy-It-Now price of $165.00 with FREE SHIPPING or if you need a Nike Covert/Vapor or the, VR-S, VR-ll/ VR Pro/Mach Speed Str. 8 sleeve or Cobra Amp Cell Pro or My Fly, or either Bio Cell/Fly Z or King LTD sleeve, driver or fairway wd. sleeve or an O.E.M. Titleist 910/913/915 sleeve or the Ping G-30 or Anser/G-25/I-25 sleeve, or the Mizuno JPX-850 or either Bridgestone sleeve, for the price of $165.00 the sleeve will be installed on the shaft to the buyer's specs, if you know which setting you currently use I will install the shaft with the trademark in the proper position. If you have the older epoxied head, ship me your driver or F/W wood, e-mail me for a quote to install this shaft in another type head. This shaft will be a real bomber in your head, especially at the longer length and if you have one of the newer removable sleeve drivers, mentioned above you can just remove your present shaft and install this new shaft and work with it and you'll see the difference or maybe your present shaft is too stiff/soft or doesn't fit you, e-mail me with your present shaft information and I can help you with the different options available. I have many shafts in all flexes so if this isn't what you are looking for let me know, I also have a shaft differential deflection frequency machine and can measure this shaft and compare it to your present shaft for comparison. Winning bidder will need to specify which sleeve is wanted, but only one sleeve will be sold with the shaft. Winning bidder will also need to let me know at which position they want the trade mark installed. Add 20.00 for shaft puring if so desired and I will position the spine in the 12:00 position if customer wants that option. Shipping will be Free to lower 48 states, with Alaska extra, USPS, Priority mail shipped with in 2 business days after clearing Paypal. Thanks for looking and check out my other items in my store. I have this shaft for sale locally so I may end the listing early.
NOTE: TO ALL BUYERS, PLEASE LET ME KNOW WHAT LENGTH THAT YOU WANT THE SHAFT TO BE AT TIME OF PURCHASE, IT IS BEST IF YOU REMOVE YOUR PRESENT SHAFT FROM THE HEAD & MEASURE IT FROM THE END OF THE SLEEVE TO THE END OF THE BUTT & E-MAIL ME THAT MEASUREMENT, AS THERE ARE MANY DIFFERENT STOCK LENGTHS NOW, BESIDES THE OLD 45 INCH DRIVER STOCK LENGTH. I ALSO WILL REPLY WITH ANY FURTHER INSTRUCTIONS & ALSO THE GRIP CHOICES FROM MY SELECTION, SO THAT YOU CAN CHOOSE WHICH GRIP YOU WANT INSTALLED ON THE SHAFT, IF I ACCEPT A LOWER PRICE FOR A SHAFT, THEN YOU WILL ONLY GET A FEW GRIP CHOICES SUCH AS GOLF PRIDE TOUR VELVETS or an OEM GRIP IF I HAVE THEM IN STOCK
NOTE: I ALSO HAVE IN STOCK THE TOUR DUAL COG SLEEVE THAT REPLACES THIS SINGLE COG SLEEVE AND HAS TWICE THE SETTINGS AS THE SINGLE COG SLEEVE FOR $10.00 EXTRA, LET ME KNOW AT CHECKOUT.
UP FOR SALE ON BUY-IT-NOW IS A MINT 45.50 inches long Mitsubishi Rayon Diamana Blueboard 63 Gram X 5ct Ladies shaft for 155.00 with FREE SHIPPING with the I-Mix or either Single Cog Callaway sleeve listed above, installed and ready to go to fit right into your driver head or I will install the shaft with any of the other sleeves listed below, if needed instead, it is in almost mint condition and is 45.50 inches long and will play 46.5-47 inches long in most drivers or I can trim it to the length that you specify or I can extend it to whatever length the buyer wants, even out to 46 inches which would make it play 48 inches long in most drivers, at the longer 48 inch length it will increase your swing speed 6-10 mph and give you between 20-30 yards more distance. The shaft will come with whichever sleeve you the buyer will need for your application from the last two pictures above or I can install into any of the epoxied heads also. This shaft is a nice looking mid/ high kick shaft, with a mid tip section to give you a low to mid ball flight, depending on your loft, swing speed, launch angle & swing type it sells for 300.00 new and is very rare and hard to come by. They have a low enough torque that they won't open up & cause a bad fade or slice. The shaft will come ready to install into your specific driver with a new grip from my stock selection and with the shaft sleeve of your choice such as any of the Taylormade sleeves,R-15, M-1, R-1, SLDR, Jetspeed, R-11, R-9, RBZ, or RBZ Stage 2 or an aftermarket Titleist sleeve for a Titleist 910/913/915 D-2 or D-3 driver or either of the fairway wd. sleeves or the Callaway I-mix or a single cog RAZR, Razr Fit, Rarz Fit Extreme, Optifit, X Hot or X Hot Pro sleeve or all the older Cobra sleeves, such as the S-2,S-3, ZL, ZL Encore, L5V or an AMP sleeve or the Cleveland Classic XL or Custom 588 or either Adams sleeve, the XTD or the Fast 12 LS/Speedline sleeve for $155.00 for either of the Dual Cog Sleeves such as the Optifit/ Razr/ X - Hot Tour sleeve or for the Big Bertha/B.B. Alpha/Optiforce/X-2-Hot, Big Bertha V-Series or the XR, Alpha 815,816/Double Diamond 815 sleeve for all the Callaway heads for the Buy-It-Now price of $165.00 with FREE SHIPPING or if you need a Nike Covert/Vapor or the, VR-S, VR-ll/ VR Pro/Mach Speed Str. 8 sleeve or Cobra Amp Cell Pro or My Fly, or either Bio Cell/Fly Z or King LTD sleeve, driver or fairway wd. sleeve or an O.E.M. Titleist 910/913/915 sleeve or the Ping G-30 or Anser/G-25/I-25 sleeve, or the Mizuno JPX-850 or either Bridgestone sleeve, for the price of $165.00 the sleeve will be installed on the shaft to the buyer's specs, if you know which setting you currently use I will install the shaft with the trademark in the proper position. If you have the older epoxied head, ship me your driver or F/W wood, e-mail me for a quote to install this shaft in another type head. This shaft will be a real bomber in your head, especially at the longer length and if you have one of the newer removable sleeve drivers, mentioned above you can just remove your present shaft and install this new shaft and work with it and you'll see the difference or maybe your present shaft is too stiff/soft or doesn't fit you, e-mail me with your present shaft information and I can help you with the different options available. I have many shafts in all flexes so if this isn't what you are looking for let me know, I also have a shaft differential deflection frequency machine and can measure this shaft and compare it to your present shaft for comparison. Winning bidder will need to specify which sleeve is wanted, but only one sleeve will be sold with the shaft. Winning bidder will also need to let me know at which position they want the trade mark installed. Add 20.00 for shaft puring if so desired and I will position the spine in the 12:00 position if customer wants that option. Shipping will be Free to lower 48 states, with Alaska extra, USPS, Priority mail shipped with in 2 business days after clearing Paypal. Thanks for looking and check out my other items in my store. I have this shaft for sale locally so I may end the listing early.
NOTE: TO ALL BUYERS, PLEASE LET ME KNOW WHAT LENGTH THAT YOU WANT THE SHAFT TO BE AT TIME OF PURCHASE, IT IS BEST IF YOU REMOVE YOUR PRESENT SHAFT FROM THE HEAD & MEASURE IT FROM THE END OF THE SLEEVE TO THE END OF THE BUTT & E-MAIL ME THAT MEASUREMENT, AS THERE ARE MANY DIFFERENT STOCK LENGTHS NOW, BESIDES THE OLD 45 INCH DRIVER STOCK LENGTH. I ALSO WILL REPLY WITH ANY FURTHER INSTRUCTIONS & ALSO THE GRIP CHOICES FROM MY SELECTION, SO THAT YOU CAN CHOOSE WHICH GRIP YOU WANT INSTALLED ON THE SHAFT, IF I ACCEPT A LOWER PRICE FOR A SHAFT, THEN YOU WILL ONLY GET A FEW GRIP CHOICES SUCH AS GOLF PRIDE TOUR VELVETS or an OEM GRIP IF I HAVE THEM IN STOCK